Fader Touch Test - Tascam DM-24 Service Manual

FADER TOUCH TEST

This test checks the faders for touch sensitivity. This test also
checks if, when a single fader is touched, only that fader senses
it or if, when two or more faders are touched, they all sense it.
1. When the DM-24 switches into the FADER TOUCH TEST
mode, the following screen will appear.
2. Touch the fader, below the on-screen image of which an
arrow mark is displayed.
The number assigned to a fader to be touched is shown in the
upper part of the screen, along with the number assigned to
the actually touched fader.
The on-screen image of the fader knob you touch goes black.
3. If the fader you touched is recognized by the DM-24, go on
to the next fader. The on-screen image of the fader having
been checked goes out.
4. When all the faders have been successfully checked, the
DIAG menu screen reappears with the FADER TOUCH
TEST item check marked.
If faders are not recognized correctly, try changing the
CLOCK setting for FADER SESITIVITY on the SET UP
sub-screen under the OPTION screen.
Also, you can set the FADER SENSITIVITY setting to [ON]
so that the ON/STATUS LED is available to check the fader
sensitivy.
To abort the fader sensisvity test, press ENTER.
11
TASCAM DM-24