Table of Contents
Advertisement
2
Product description
4
2
3
1
Fig. 1
Oil/gas-fired boiler Logano G515
[1]
Boiler shell (jacket)
[2]
Thermal insulation
[3]
Boiler heat exchanger
[4]
Control panel assembly
1
1
1
Fig. 2
Front jacket
[1]
Boiler shell (jacket)
Logano G515
Heating oil
Remarks
The Logano G515 boiler can be operated with the specified fuels. Select a burner suitable for use with the fuels specified for the
Logano G515 boiler.
The output figures shown in the Tab. "Technical Data" are nominal power figures.
Carry out maintenance and cleaning procedures annually. Check that the entire system is functioning correctly.
Immediately remedy faults.
If heating oil is used, shorter maintenance intervals may be necessary depending on the operating time.
Table 2
Logano G515 – 6 720 647 208 (2014/09)
The Logano G515 oil/gas-fired boiler is supplied with or without a burner
You can obtain undrilled or predrilled burner plates (hole pattern
depends on burner) as accessories from Buderus.
The predrilled burner plate is included in the scope of delivery for the
Logano G515 with oil or gas-fired fan-assisted burners.
1
The main components of the Logano G515 oil/gas-fired boiler are:
• Boiler block ( Fig. 1, [3]) The boiler heat exchanger transfers the
heat generated by the burner to the boiler water.
• Boiler shell (jacket, ( Fig. 1 [1] and Fig. 2, [1]), thermal insulation
( Fig. 1, [2]). The boiler jacket and thermal insulation minimize
energy loss.
• Control panel ( Fig. 1, [4]). The control panel is designed to
monitor and control all electrical components of the Logano G515
6 720 642 624-01.1O
oil/gas-fired boiler.
6 720 642 624-02.1O
Fuels
Liquid propane (LPG)
Product description
NOTICE: Risk of system damage from use of incorrect
burner.
▶ Only use burners that meet the technical
requirements of the oil/gas-fired boiler Logano
G515 ( Chapter 3, page 8).
Observe all standards and guidelines applicable to the
installation and operation of the system in your country.
Please observe the information on the boiler rating plate.
To prevent boiler contamination, we recommend
installing a dirt trap in the water system.
As a basic rule, flush existing systems before connecting
the boiler.
Install a desludging unit in the boiler return to prevent
damage to the boiler.
Natural gas (NG)
2
5
Hide quick links:
Advertisement
Table of Contents
