Table of Contents
Advertisement
Right and left-hand installation on...
Total number of
Front section
boiler sections
Section no.
7
1
8
1
9
1
10
1
11
1
12
1
Table 12
7.9.2
Fitting the profile rails
▶ Fasten top front crosswise profile rails ( Fig. 37, [2]) to the cast
lugs ( Fig. 37, [1 and 4]) and screw on hand-tight with hexagon
bolts (M8 × 16). The folded edge on the front profile rail must face
forward.
▶ Fasten top rear crosswise profile rail ( Fig. 37, [3]) onto the cast
lugs and screw in place with hexagon bolts (M8 × 16). The folded
edge of the rear profile rail must point toward the rear.
▶ You can only align the longitudinal rails or brackets
before placing the thermal insulation.
▶ Align the longitudinal rails or brackets correctly prior
to installation of the side panels, covers and thermal
insulation.
2
1
Fig. 37 Fitting the crosswise profile rails
▶ Place the longitudinal rails ( Fig. 38, [1 and 2]) on both brackets
on the rear and front section.
▶ Push longitudinal rails with pre-fitted screws ( Fig. 38, [3]) into
the notches in the brackets ( Fig. 38, [4]) and screw together.
Logano G515 – 6 720 647 208 (2014/09)
Intermediate
section
Rear section
Section no.
Section no.
4
7
4
8
5
9
5
10
4 and 7
11
4 and 8
12
3
4
720 42 23-35.1o
1
Fig. 38 Installing the longitudinal rails
▶ Place longitudinal rail ( Fig. 39, [1]) with the notch at the front on
the notch of the crosswise profile rail ( Fig. 39, [2]).
▶ The longitudinal rail must be pushed from below against the
crosswise profile rail at the rear of the boiler.
1
Fig. 39 Place longitudinal rail on crosswise profile rail
7
Boiler block assembly
2
4
3
720 42 23-3 .1o
2
720 42 23-37.1o
23
Hide quick links:
Advertisement
Table of Contents
