Table of Contents
Advertisement
▶ Push the center boiler cover with the folded edges ( Fig. 53, [1])
under the front boiler cover and insert into the bead of the side
panels.
1
Fig. 53 Fitting the center cover
▶ Fit the rear boiler cover on the side panels with the folded edges and
cut-out for the heating circuit flow ( Fig. 54, [1]) facing toward the
front.
1
Fig. 54 Fitting the rear cover
▶ Push upper rear boiler panel under the rear boiler cover ( Fig. 55,
[1]) and screw to the side panels from the back using four self-
tapping screws ( Fig. 55, [2]).
Logano G515 – 6 720 647 208 (2014/09)
Fig. 55 Fitting the rear boiler panel
720 42 23-51.1o
▶ Insert snap nuts into the left and right-hand side panels and also the
rear boiler panel sections ( Fig. 56, [1, 3, 4, and 8]).
▶ Hang the bottom rear boiler panel sections on the left and right into
the slots in the folded edge of the upper rear boiler panel and the side
panel ( Fig. 56, [5]).
▶ Secure the rear panel sections of the boiler to the side panels with
self-tapping screws.
▶ Screw the connecting plate ( Fig. 56, [2]) below the flue outlet to
the rear boiler panel sections using self-tapping screws.
▶ Fasten the plastic cable entries to the left or right-hand side of the
upper rear boiler panel ( Fig. 56, [6 and 7]).
5
4
3
720 42 23-52.1o
Fig. 56 Installing the rear boiler panel sections
7
Boiler block assembly
1
2
720 42 23-53.1o
7
8
1
2
720 42 23-54.1o
29
Hide quick links:
Advertisement
Table of Contents
