Network Settings; Ip Address Setting - Kyocera KM-2050 Basic Operation Manual

Network Settings

IP Address Setting

BASIC OPERATION GUIDE
Use the following procedure to register an IP Address to the machine.
Check with your network administrator before performing this procedure.
The following procedure applies when DHCP is Off and TCP/IP is On.
Refer to Chapter 2, Advanced Operation Guide for details.
NOTE:
Any changes made to network settings become valid after you
power the machine off and on again.
1 Press [Printer].
2
Press or to select MENU
and press [Enter].
3 Press or to select Interface
and press [Enter].
4
Press or to select Network
and press [Enter].
5
Press or to select TCP/IP
and press [Enter].
6 Press or to select Change #
and press [Enter].
Ready
GO
CANCEL
MENU
Menu
Back
Print Status Page
Interface
Interface
Back
Parallel
Network
Network Setting
Back
NetWare
TCP/IP
TCP/IP
On
Off
Change #
Preparation
2-13