Kyocera KM-2050 Basic Operation Manual page 105

Message
MemoryCard err Press
GO
Memory card error Insert
again.
Insert same memory
card
Format error Memory
card
Print overrun Press GO. Printing has not been performed correctly due to insufficient
Interface occupied
Checksum Error
BASIC OPERATION GUIDE
An error has occurred in writing to or reading from the Memory
Card.
• Press [Printer] and press
[Enter]. The error is cleared.
The Memory Card has been removed during printer setup.
Insert the Memory Card.
NOTE:
When inserting the Memory Card, switch off the main
power ( ).
The machine tried to read data from the Memory Card and did not
recognize the Memory Card.
Insert the Memory Card again.
NOTE:
When inserting the Memory Card, switch off the main
power ( ).
The Memory Card inserted in the machine must be formatted.
Format the Memory Card.
memory.
• Press [Printer] to display the following messages.
- GO: Continues printing. Processed data will be output and
remaining data will be printed on the next page.
- CANCEL: Cancels printing.
- RESET: Resets the printer board. In this case, only the
printer functions will be reset.
• Press or to select the option required and press [Enter].
If the Auto Continue setting has been enabled, printing
automatically resumes after a preset period of time.
After this error message displays, Page Protect mode is
automatically enabled.
The selected interface is currently being used. Wait for a while
and retry.
The machine has detected an error at startup.
Switch off the main power and then switch on again. If the same
message appears, contact your Service Representative or
Authorized Service Center.
Procedure
or to select [GO] and press
Troubleshooting
Reference
page
—
—
—
—
—
—
—
6-9