Editing Aux Values - Sequentix P3 SEQUENCER Operation Manual

Sequentix Music Systems

Editing Aux Values

With the current aux configured for the function you want, you can now set the values for each step
using the UPPER knobs, just as for velocity, length and delay.
One difference with auxes is that each numeric value also has a corresponding on/off status value too.
A controller message will only be sent, or an event processed, if the aux status is active.
*TIP By default, when you edit the value of an aux if the step is not active it will be turned on
automatically. This feature can be disabled with the "aux edit sets on" User Conf option described in
the play mode chapter.
As we saw earlier when looking at step LED colours for status rows, the active status for gate is always
shown on the step LEDs in pattern edit.
This is still the case in aux mode - the step LED colours show the following conditions:
As with the other status rows, each press of a step key will toggle the aux status for that step on and
off.
P3 Sequencer User Manual Page 61