Sequentix P3 SEQUENCER Operation Manual page 27

Sharps or Flats
You may find that the note name for the root note is not what you would like.
For example, you think of the key as E flat rather than D sharp.
You can switch the note display format as follows:
hold the FUNC key on the keypad
•
press the step key for the FTS root note
•
This will toggle the display of 'black' note names between sharps and flats.
This setting is stored for each part, and also determines how note names will be shown in pattern edit.
Selecting the FTS Scale
To change the FTS scale, use the DATA knob to scroll through the available options.
There are 23 preset and 9 user defined scales.
Again, the change will not take effect until "apply" is pressed.
See Appendix A for a list of the preset scale definitions.
Exit FTS Config
To exit the FTS configuration page:
press "save", F1, to store the new FTS settings, and return to play mode
•
OR
• press "lose", F3, to restore the previous settings, and return to play mode
The FTS settings are stored for each part.
They are recalled whenever a part becomes active.
P3 Sequencer User Manual
Sequentix Music Systems
Page 27