Sequentix P3 SEQUENCER Operation Manual page 129

The first is the target value - the pattern value (note, velocity, length, etc.), you are going to be moving
around.
Virtually all of the values can be used, as well as some combinations, so we'll not list them yet.
The second value sets the target track.
As you move the UPPER knob, you will find it only adjusts the number for "Track:" between 1 and 8,
and that the word "note" remains on the top line.
This is because the knobs normally only edit the target track.
To change the target value:
hold the FUNC key
•
move the UPPER knob
•
While the FUNC key is held, the UPPER knob s allow you to scroll through all the possible target
values on the top line of the display.
The target track numbers will continue to change too, but you have much finer control over those once
you release FUNC to select a specific track.
Let's get back to the example pattern...
adjust the UPPER knob on step 1 to show "Track: 2" in the display
•
If the display shows anything other than "grab note" on the top line:
hold the FUNC key
•
adjust UPPER knob 1 until you see "grab note"
•
• release the FUNC key
adjust the knob again to "Track: 2"
•
The display should confirm you have entered the correct values like this:
Repeat this on each of the three other steps, 5, 9 and 13.
Now, as your previously boring pattern plays, you will hear different notes play on steps 1, 5, 9 and 13.
P3 Sequencer User Manual
Sequentix Music Systems
Page 129