Battery Mounting - Carson SPY HAWK Basic Instruction Manual

5. Elevator sensitivity setup - Expert mode
Hold down the Elevator/Aileron or (mode 1: Elevator/Rudder) stick for 1
second to enter the setting status, press Throttle/Rudder or (mode 1:
Elevator/Rudder) key until the five-point dotted line symbol start to
flash (see picture below), press Elevator Trim to idea sensitivity and then
hold down the Elevator/Aileron or (mode 1: Elevalor/Rudder) stick for 1
second to confirm and exit.
GB
6. Aileron sensitivity setup - Expert mode
(3CH exception)
Hold down the Elevator/Aileron or (mode 1 : Elevator/Rudder) stick for 1
second to enter the setting status, press Throttle/Rudder or (mode 1:
Elevator/Rudder) key until the five-point dotted line symbol start to
flash (see picture below), press Aileron Trim to idea sensitivity and then
hold down the Elevator/Aileron or (mode 1: Elevator/Rudder) stick for 1
second to confirm and exit.
h. Battery Mounting
Notice:
• Do not mix old and new batteries.
• Do not mix different types of batteries.
• Do not charge non-rechargeable battery.
1
Release the screw
4
46 CARSON Spy Hawk • 50 050 5019 + 20 + 21 + 22
2
Take out the cover
Push
Return the cover
Push
5
Fasten the screw
Flashing
Flashing
3
According to the correct
polarities, install 4 x AAA ballery