Charging The Lipo Flight Battery - Carson EasyTyrann 180 Instruction Manual

Charging the LiPo Flight Battery

A. Charging via
transmitter
B. Charging via
USB cable
1. Turn the helicopter off.
2. Charging via transmitter:
First, please switch on the transmitter. Put down the charging wire
cover of the controller and put out the charging wire, then put it
into the interface of the helicopter. The Green LED on the controller
"CHA" will turn on. The charging time is about 50 - 60 minutes.
When the charging is completed, the Green LED on the controller
"CHA" will turn RED.
The charging time can be 50 - 60 minutes
The flying time is about 6 minutes.
The helicopter is equipped with a LiPo bat-
tery, please also pay attention to the follow-
ing cautions and safety advices:
• Do not use or leave the battery near a heat source such as fire or
heater. Otherwise the battery will cause damage or explode.
• Do not slam the battery or beat to hard surface.
CARSON Easy Tyrann 180 2.4 GHz-Version 500507048
Charging wire on transmitter
3. Charging via USB cable:
Put the USB charging wire into your computer USB interface, the
charging wire will be lightened. Put the other side of the USB
charging wire into the helicopter's interface. The USB charging wire
light will be turned off. The charging time is about 50 - 60 minutes.
The charging wire light will turn on, then the helicopter is fully
charged.
• Do not immerse the battery in water, and keep the battery in a
cool dry place.
• The charger included with this product can only be used for the
product's charge.
• Do not disassemble the battery.
• Never leave the battery unattended during charging.
25