Qualcast cgt183a Operating Instructions Manual

Qualcast cgt183a Operating Instructions Manual

18 volt cordless grass trimmer

Advertisement

cgt183a
OPErating instructiOns
18 Volt
cordless grass trimmer
HElPlinE nO 0844 8010979

Advertisement

Table of Contents
loading

Summary of Contents for Qualcast cgt183a

  • Page 1 OPErating instructiOns 18 Volt cordless grass trimmer HElPlinE nO 0844 8010979...
  • Page 2: General Power Tool Safety Warnings

    Original instructiOns gEnEral POwEr tOOl reduces the risk of electric shock. f) If operating a power tool in a damp safEty warnings location is unavoidable, use a residual current device (Rcd) protected supply. WARNING! Read all safety warnings Use of an RCD reduces the risk of electric and all instructions.
  • Page 3 Original instructiOns dust-related hazards. another battery pack. b) Use power tools only with specifically 4) PoWeR tool uSe ANd cARe designated battery packs. Use of any a) do not force the power tool. use the other battery packs may create a risk of correct power tool for your application.
  • Page 4: Maintenance

    Original instructiOns syMBOls they do not play with the appliance. If the supply cord is damaged, it must be replaced by the manufacturer, its service To reduce the risk of injury, user agent or similarly qualified persons in order to must read instruction manual avoid a hazard.
  • Page 5: Cutting Head Assembly

    Original instructiOns SWItcH lock off ButtoN BAtteRy ReleASe ButtoN BAtteRy PAck oN/off SWItcH HeAd RotAtIoN lockING MecHANISM HeIGHt AdjuStMeNt lockING MecHANISM flAtteNING HeAd AdjuStMeNt ButtoN SAfety GuARd cuttING HeAd ASSeMBly 10. edGe GuIde 11. MotoR HouSING 12. AuxIlIARy HANdle 13. cuttING HeAd coveR (See fig S ) 14.
  • Page 6: Fitting The Auxiliary Handle

    Original instructiOns Note: Before using the tool, read the WARNING! Take great care when doing instruction book carefully. this as the guard has a very sharp cutting edge. (See Fig C) assEMBly/aDJustMEnt WARNING! The guard must always be on the tool to protect the user. 1.
  • Page 7: Charging Your Battery Pack

    Original instructiOns The auxiliary handle’s bracket can be moved up or down on the shaft and the auxiliary handle itself can be moved forward or backward into 5 different locked positions Then tighten the auxiliary handle locking knob. 5. AdjuSt tHe HeIGHt (See fig e) To adjust the telescopic shaft, simply pull the height adjustment locking collar down and pull the bottom section of the shaft down to...
  • Page 8: Operation

    Original instructiOns 3. HoW to cHARGe youR BAtteRy PAck insert the battery pack into grass trimmer’s (See fig H) battery port. A simple push and slight Connect the battery charger to the power pressure will be sufficient. supply and the green light will illuminate. Then, put the charger base on battery pack to make connections and the light will turn to orange to show charging has started.
  • Page 9 Original instructiOns check for the following: 4.If the grass is very long cut in stages rather Wear eye protection and heavy clothing. than trying to cut in one go. Do not overload Hold front handle with one hand and your trimmer, take small cuts this will keep auxiliary handle with the other hand.
  • Page 10 Original instructiOns 6.cutting edges the line is at the desired length. To edge, rotate the shaft 180 . Place edge guide and trimmer head above the surface you are going to edge, as shown in Fig P. to ReMove tHe cuttING HeAd coveR (See fig R,S) Press the release latch on the spool head cover and remove cover, pulling it straight off...
  • Page 11: Troubleshooting

    Original instructiOns WHeN RefIttING tHe SPool cAP 3. Never use water or chemical cleaners to Keep all areas of the cutting head cover and clean your power tool. Wipe clean with a spool holder clean. dry cloth. Replace the spool head cover, pressing firmly 4.
  • Page 12: Technical Data

    Original instructiOns tEcHnical Data cGt183A Voltage 230-240V~ 50Hz Power input No load speed 8000/min Cutting diameter 25cm Line diameter 1.45mm Line length 1*4m Machine weight 2.65kg Normal charging time 3-5hr Battery capacity 1.5Ah nOisE anD ViBratiOn Data A weighted sound pressure...
  • Page 13 Original instructiOns Avoid using tools in temperatures of 10 C or less. Plan your work schedule to spread any high vibration tool use across a number of days. accEssOriEs Auxiliary handle charger Safety guard Battery pack We recommend that you purchase your accessories from the same store that sold you the tool.
  • Page 14: Environmental Protection

    Original instructiOns EnVirOnMEntal PrOtEctiOn Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local Authority or retailer for recycling advice. 18 Volt cordless grass trimmer HElPlinE nO 0844 8010979...

Table of Contents