Quick and easy to start CARRY STRAP / HARNESS INCLUDED For greater control and comfort AFTER SALES SUPPORT UK / IRELAND HELPLINE NO 0151 6491500 REP . IRELAND HELPLINE NO 1890 946244 WEB SUPPORT www.einhell-uk.co.uk MODEL NUMBER: QG-BC 30 MANUFACTURERS ARTICLE NUMBER: 34.018.90...
Contents Safety Guide Assembly and Parts list Getting Started Operation Trouble Shooting Declaration of Conformity Guarantee Certificate Helpline No. UK 0151 649 1500 / IRE 189 094 6244...
Explanation of the information signs on the equipment: 1. Warning! 2. Read the instructions for use before operating the equipment. 3. Wear safety goggles, a face guard and ear defenders. 4. Wear sturdy, non-slip footwear. 5. Wear safety gloves. 6. Protect the equipment from rain and damp. 7.
Safety Information Handling 1. Wear close fitting, tough work clothing that 1. Read the instructions with due care. Familiarize will provide protection, such as long slacks yourself with the settings and proper operation or trousers, protective footware, heavy duty of the machine. work gloves, hard hat, a safety face shield, 2.
engine off immediately and examine INFLUENCE OF ALCOHOL OR DRUGS. the equipment. Never operate unit with 10. DO NOT OPERATE UNIT UNLESS SAFETY GUARD damaged or defective equipment. IS INSTALLED AND IN GOOD CONDITION. 16. Always trim or cut at high engine speeds. 11.
Important! 2. Machine description and items When using the equipment, safety precautions supplied (Fig. A – C) must be observed to avoid injuries and damage.Please read the complete operating 1. Line Spool Assembly instructions and safety regulations with due 2. Guard for blade with screws care.
3. Proper use The machine is designed for cutting lawns and 5. Before starting the equipment grassed areas. Important. Due to the high risk of bodily injury 5.1 Assembly to the user, the brush cutter must not be used to carry out the following work: to clean (suck up) 5.1.1 Installing the additional handle dirt and debris off walkways, or to chop up tree...
order to remove the blade. 5.3 Fuel and oil 5.1.4 Installing the cutting line guard hood Recommended fuels Important: The cutting line guard hood must be Use only a mixture of normal unleaded petrol fitted if you wish to work with the cutting line. The and special 2-stroke engine oil.
Important: Never allow the starter cable Normal procedure: to snap back. This may damage the Let go of the throttle lever and wait until the machine. engine has changed to idling speed. Then Important: The cutting tool starts to operate set the ON/OFF switch to “Stop”...
LOWER TRIMMING MOWING Hold the trimmer right in front of you at a For mowing you should cut all the vegetation slight angle so that the underside of the down to the ground. To do this, set the cutter head is above the ground and the line cutting head at an angle of 30°...
housing (Fig. N3). Make sure that you do not 7.2.3 Maintenance of the spark plug lose the spring or the washers. (Fig. K1-K2) 3. Remove any remaining cutting line. Spark plug gap = 0,6 mm. Tighten the spark 4. Place the new cutting line in the center plug with a torque of 12-15 Nm.
Setting the throttle cable: 2. Drain the fuel out of the tank (You can use If the maximum speed of the machine a plastic petrol pump for this purpose, falls over time and you have ruled our which can be bought via our all the other causes listed in section 9 HELPLINE 0151 649 1500).
Please quote the following data when ordering replacement parts: The unit is supplied in packaging to prevent its • Type of model/Machine QG-BC 30 being damaged in transit. This packaging is • Article number of the machine 34.018.90 raw material and can therefore be reused or •...
Please adhere to the following maintenance periods in order to ensure a failure-free operation. Important! Fill in engine oil and fuel before starting up the engine for the first time. After an After an After an After an Before operating operating operating operating...
The reprinting or reproduction by any other means, in whole or in part, of documentation and papers accompanying products is permitted only with the express consent of ISC GmbH. Helpline No. UK 0151 649 1500 / IRE 189 094 6244...
GUARANTEE CERTIFICATE Dear Customer, In the unlikely event that your device develops a fault, please contact our Customer service department on the telephone number shown below. 1. These guarantee terms cover additional guarantee rights and do not affect your statutory warranty rights. Claims must be accompanied by Proof of Purchase.
AFTER SALES SUPPORT UK / IRELAND HELPLINE NO 0151 6491500 REP . IRELAND HELPLINE NO 1890 946244 WEB SUPPORT www.einhell-uk.co.uk MODEL NUMBER: QG-BC 30 MANUFACTURERS ARTICLE NUMBER: 34.018.90...