Table 3: Default Route Preferences - Alcatel-Lucent 7210 SAS M Configuration Manual

Configuration Commands
tag — Adds a 32-bit integer tag to the static route. The tag is used in route policies to control

Table 3: Default Route Preferences

enable — Static routes can be administratively enabled or disabled. Use the enable parameter to re-
disable — Static routes can be administratively enabled or disabled. Use the disable parameter to
bfd-enable — This parameter is supported on 7210 SAS M, X devices configured in Network mode.
It associates the state of the static route to a BFD session between the local system and the configured
nexthop. This keyword cannot be configured if the nexthop is indirect or blackhole keywords are
specified.
Page 50
distribution of the route into other protocols.
Route Type
Direct attached
Static-route
OSPF Internal routes
IS-IS level 1 internal
IS-IS level 2 internal
OSPF External
IS-IS level 1 external
IS-IS level 2 external
BGP
Default 5
Values
1 — 4294967295
enable a disabled static route. In order to enable a static route, it must be uniquely identified by
the IP address, mask, and any other parameter that is required to identify the exact static route.
The administrative state is maintained in the configuration file.
Default enable
disable a static route while maintaining the static route in the configuration. In order to enable a
static route, it must be uniquely identified by the IP address, mask, and any other parameter that
is required to identify the exact static route.
The administrative state is maintained in the configuration file.
Default enable
Preference Configurable
0 No
5 Yes
10 Yes
15 Yes
18 Yes
150 Yes
160 Yes
165 Yes
170 Yes
7210 SAS M, X Router Configuration Guide