Configuring The Video Inputs; Figure 3-12 Video Input Detail Page; Procedure 3-8 Configuring The Video Inputs - American Dynamics VideoEdge User Manual

4-channel ip encoder

Hide thumbs Also See for VideoEdge:

Table of Contents

Web Configuration

Configuring the Video Inputs

The Video Input Detail page allows the configuration of the video format and the camera control

protocol for each attached camera.

Note

The Serial ports and Sensornet configurations should be completed before the Video Input

configuration, as detailed in Procedure 3-8.

1 Ensure that the browser is displaying the Configuration page (if not refer to Procedure 3-3).

2 From within the Video Inputs section select the Edit button of the first Video Input to be

configured.

A Video Input detail page is displayed, as shown in Figure 3-12.

3 Enter the required Name for the Video Input.

4 Select the required Video Format from the drop down menu. The options are Auto, NTSC and

PAL. The default setting is Auto, which will auto detect the incoming video stream format.

5 Select the required PTZ Protocol from the drop down menu. The options available in the drop

down list will vary with the protocols that are available. The default setting is None.

6 Select the required Port from the drop down menu

Note

For RS-422 and RS-485 Serial Port 2 must be selected.

3-16

Installation and User Guide

Table of Contents