Features; Connections - American Dynamics VideoEdge User Manual

4-channel ip encoder

Hide thumbs Also See for VideoEdge:

Table of Contents

Introduction

Figure 1-2 shows an example system configuration where the IP Encoder is installed as part of a

full Intellex IP Network. In this example the IP Encoder is connected to the Intellex through a

network switch.

Features

The VideoEdge™ IP Video Encoder has the following physical connections:

• 4 Composite BNC 75 ohm connectors — for connection to analog cameras;

• 4 RJ45 Serial ports — for use with PTZ camera control, text input;

• 1 Sensornet port — for use with a Sensornet network;

• 4 Event (Alarm) inputs & 6 Event (Alarm) outputs (output alarms not supported at this

release);

• 4 Audio input/ouptut — one for each camera (not supported at this release);

• Power jack — for use with the power supply model; and

• 1 RJ45 network connection — for connection to the 10/100 BaseT Ethernet network.

1-2

Figure 1-2 Example of an IP Encoder in a full system installation

Installation and User Guide

Table of Contents