Installation Method B- Post Installation-Configuration - American Dynamics VideoEdge User Manual

Installation Method B— Post installation-configuration
Refer to the IP Encoder Quick Start Guide to install the Encoder to
the network and connect the Video feeds, Serial ports, Sensornet,
Event In/Out and power cables.
Note: For PoE models there are no power supply cables to connect.
Refer to the Intellex Setup Guide and follow the procedure for adding
an IP Encoder.
From within the Intellex, select Device Setup for the new IP Encoder.
This will display the IP Encoder Main Page within a browser window.
Refer to section 3 Web configuration and configure the following
settings on the IP Encoder:
TCP/IP settings
Serial ports
Sensornet (if applicable)
Video Inputs
Event Inputs (if applicable)
Using the Intellex Setup and User Manuals, configure any other required
advanced features.
Note
When using installation method B only 1 IP Encoder, with the default settings, should be powered
up and added to the network at a time.
Remove the IP Encoder from the packaging
Note: If Video feeds are available
the Live Video function can also be
used to verify the video is being
captured correctly by the IP Encoder.
Installation
2-3