Input Setup; Output Setup - Sonance SONAMP DSP 2-150 Instruction Manual

SONAMP DSP 2-150 MULTI-CHANNEL POWER AMPLIFIER INSTRUCTION MANUAL

Input Setup

Input Name
This is a user entered field with a maximum of 16 characters.
Use these fields to describe the type of input connected.
Input Trim dB
This pull down menu allows for input levels to be adjusted +/-6dB.
This gives you the ability to level out all your inputs so when you
switch from input to input the levels will be equal. This can eliminate
any harsh transitions between sources with different output
voltages. Select the pull down menu in each channel to adjust
the level trim between plus or minus 6dB in increments of .5dB

Output Setup

Output Name
This is a user entered field with a maximum of 16 characters.
Use these fields to describe the location of the speakers.
Stereo / Mono
Allows each channel to be set for Stereo or Mono operation. When
Mono is selected the Left and Right of the input selected will be
combined to create Mono.
DSP Preset
Apply any of the available Sonance DSP presets to each channel of
the amplifier independently.
You can apply any open preset and then make modifications on the
EQ Settings page.
Output Group
The DSP 2-150 has two Output Group options A-B.
When using IP or IR to control the amplifier, commands are sent to
an output group and not to a specific channel.
Bridge Mode
When more power is required two channels can be bridged.
Follow the instructions on page 7 for connecting the wires then
select Bridge ON.
14