Quick Setup Page - Sonance SR 2-125 Instruction Manual

S R 2 - 1 2 5 T W O - C H A N N E L A M P L I F I E R I N S T R U C T I O N M A N U A L

Quick Setup Page

Quick Setup
Audio - Auto On
Select the Audio Auto On mode you would like to use, either ON
or OFF.
Audio Auto On - ON
When the Audio Auto On switch is in the ON position the amplifier
will power off after 15 minutes without an audio signal present on
any of the channels. When an audio signal is applied the amplifier
will take approximately 9-12 seconds to reproduce audio after
going through its power up sequence.
NOTE: THE AUDIO AUTO ON - ON MODE USES THE LEAST AMOUNT
OF AC POWER WHEN THE AMPLIFIER IS NOT OPERATING.
FIGURE 15: SR 2-125
AUDIO AUTO ON - ON
Audio Auto On - OFF
When the Audio Auto On switch is in the OFF position the amplifier
will enter Sleep Mode after 15 minutes without an audio signal
present on any of the channels. When an audio signal is applied the
amplifier will take approximately 2-3 seconds to reproduce audio.
FIGURE 16: SR 2-125
AUDIO AUTO ON - OFF
Apply DSP Preset
The SR 2-125 amplifier includes pre-programmed DSP presets.
These presets are selected utilizing first the EQ Preset Bank
dial, followed by the EQ Preset Selection dial (see included DSP
Preset Matrix). The first EQ in any bank will be Flat. To select the
appropriate preset for your environment please see the included
DSP preset Selection Matrix.
FIGURE 17: SR 2-125 EQ PRESET BANK & EQ PRESET SELECTION
9