Table of Contents
Advertisement
Adjustment
11
Thread-catcher height
.05.10
● Loosen screw 1 enough so that thread catcher 2 can be turned.
● Loosen the screws in retaining collar 3.
● Bring the take-up lever to its TDC by turning the balance wheel.
● Move thread catcher 2 in accordance with the requirement.
● In this position, and taking care to ensure that retaining collar 3 is touching the shaft
11 - 23
Requirement
When thread catcher 2 2 2 2 2 is pushed forwards manually with the take-up lever at its TDC, the
lower point of the thread catcher must pass 1 mm over the back of hook 4.
Fig. 11 - 21
bushing, tighten screws 3 of the retaining collar.
Screw 1 remains loosened for the following adjustment.
4
2
3
1
Advertisement
Table of Contents
