Table of Contents
Advertisement
Adjustment
11
Engaging solenoid
.05.04
● Bring the machine to needle rise position by turning the balance wheel.
● Loosen screw 1 until the engaging solenoid can be turned with difficulty.
● Manually activate engaging lever 2 2 2 2 2 so that pawl 3 engages.
● Press solenoid planger 4 as far as possible into solenoid housing 5 and move both the
● In this position tighten screw 1.
11 - 17
Requirement
In needle rise position and with engaging solenoid 5 activated, there must be a distance
of 0.3 mm between engaging lever 2 and pawl 3.
3
2
Fig. 11 - 15
solenoid housing and the solenoid planger in accordance with the requirement.
4
5
1
5
Advertisement
Table of Contents
