11
Top feed lifting motion
.04.06
Requirement
When the balance wheel is turned, lifting presser 3 and needle point 6 must reach the
needle plate at the same time.
Fig. 11 - 06
● Push lever 1 (screw 2) fully up in its slot.
● Lower lifting presser 3 onto the needle plate.
● Loosen screws 4 just enough to allow eccentric 5 to be turned on its shaft.
● Turn eccentric 5 according to Requirement.
● Tighten screws 4.
5
6
3
1
2
4
4
Adjustment
11 - 8