Table of Contents
Advertisement
FabiaTech Corporation
ATA (PI) 80 Pin Cable Detection
Set this option to select the method used to detect the ATA (PI) 80 pin cable. The
use of an 80-conductor ATA cable is mandatory for running Ultra ATA/66, Ultra
ATA/100 and Ultra ATA/133 IDE hard disk drives. The standard 40-conductor ATA
cable cannot handle the higher speeds.
Available options: Host & Device, Host, and Device
Default setting: Host & Device
SuperIO Chipset - Configuration ITE8712 Super IO Chipset
This section describes the function of Super I/O settings.
Serial Port 1 Address
These fields select the I/O port address for each Serial port.
Available Options: Disabled, 3F8H/IRQ4, 3E8H/IRQ4, and 2E8H/IRQ3.
Default setting: 3F8H/IRQ4
Serial Port 2 Address
These fields select the I/O port address for each Serial port.
30
Advertisement
Table of Contents
