Clearances To Combustibles; Pedestal Assembly - Regency F33-NG1 Owners & Installation

F33 freestanding
Table of Contents

Advertisement

INSTALLATION
This includes:
1)
Clocking the appliance to ensure the correct firing rate
(rate noted on label) after burning appliance for 15 min-
utes.
2)
If required, adjusting the primary air to ensure that the flame
does not carbon. First allow the unit to burn for 15-20 min.
to stabilize.
3)
Check for proper draft.
CAUTION: Any alteration to the product that causes sooting or
carboning that results in damage is not the responsibility of the
manufacturer.

CLEARANCES TO COMBUSTIBLES

The clearances listed below are MINIMUM distances. Measure
the clearance to both the appliance and the chimney connector.
The farthest distance is correct if the two clearances do not
coincide. For example, if the appliance is set as indicated in one
of the diagrams but the back wall is too close, move the stove until
the correct clearance to the connector is obtained.
This appliance may be installed only with the clearances as
shown in the situations pictured. Do not combine clearances
from one type of installation with another in order to achieve
closer clearances. Use the minimum clearances shown in the
diagrams.
F33-1 Clearance to Combustibles
A Side Wall to Unit
B Back Wall to Unit
E Side Wall to Unit
F33-1 Reference Dimensions
C Back Wall to Flue Centerline
D Side Wall to Flue Centerline
F Side Wall to Flue Centerline
Minimum ceiling height is 914 mm from top of unit.
6
1)
For easier assembly, tip the stove on its back (preferably
onto a soft surface to prevent scratching).
2)
Unscrew the 4 bolts in the underside of the stove. Align the
holes in the corners of the pedestal top with the correspond-
ing holes in the base of the stove. Use washers which are
supplied with the pedestal as shown in diagram. Reinstall
bolts.
3)
Push the Regency logo into the two holes in the front bottom
left corner of the pedestal cover plate.
Note: Any paint touch up should be done prior to placing
4)
See wiring instructions below.
250 mm
150 mm
38 mm
292 mm
559 mm
330 mm

PEDESTAL ASSEMBLY

logo on pedestal.
Diagram 1
Regency F33-1 Freestanding Gas Stove

Advertisement

Table of Contents
loading

This manual is also suitable for:

F33-lpg1

Table of Contents