Table of Contents
Advertisement
Setting up
9
Selecting a seam program
.06
To avoid the machine starting accidentally, to begin with the TE key must be pressed, af-
ter the machine has been switched on. The machine is then in its basic position and offers a
number of possibilities for selecting seam programs.
- Direct selection of the seam pattern and its individual adaptation by changing the speed
- Selection of the seam program via a program station. For this purpose a seam pattern with
- With the selection of a sequence several seam programs are sewn after each other. For
9
Selecting and changing the seam pattern.
.06.01
●
●
●
X
●
Y
●
●
30
and size factors.
its respective speed and corresponding size factors must have been stored previously.
this purpose a sequence must have been compiled beforehand from individual seam pro
grams (program stations).
With the machine in the basic position, select the direct seam pattern.
11
With the corresponding +/- key select the desired seam pattern, e.g. 11. The seam pat-
terns are stored in the machine under program numbers, see Chapter 11.06 Summary of
the seam patterns.
Select the desired speed with the corresponding +/- key.
Enter the desired size factor (in %) (X-direction) with the corresponding +/- key.
Enter the desired size factor (in %) (Y-direction) with the corresponding +/- key.
Conclude the input by pressing the TE key. (The machine changes to the sewing mode).
The enlargement of the seam pattern is limited by the size of the machine's se-
wing area.
The altered speed and size factors entered are not stored when the machine
changes to another seam program. If you wish to store these values, a station
key must be reserved with the corresponding seam program, see Chapter 11.01
Reserving program stations.
X
Y
2500
100
100
Advertisement
Table of Contents
