Table of Contents
Advertisement
WPS-300-ENC-4IP Installation Manual
12.10- Event Settings
Pg. 30
12.10.1- Motion Detection
Provides up to 3 areas to select for detecting motion on the Encoder. When configured, an action such as
recording video, taking a snapshot or series of snapshots, and/or sending email notification can be
performed after the motion is detected.
See Section
2- Configure Motion Detection Areas
Enable
Select the channel to activate the configuration for the channel, when
Ch 1 to 4
activated the selected events next to the channel will be performed.
FTP
SD Card
Relay 1 to 4
12.10.2- Area 1,2,3
Set
Select the area to activate the configuration for the area, when activated
the selected events next to the area will be performed.
Clear
Clears the area set for motion detection.
Sensitivity
Adjustable from 1 (Requires higher amount of motion to trigger) to 10
(Requires low amount of motion to trigger).
Interval
Selects the time between motion events within the image to stop recording.
12.10.3- Record File
File Format
Selects the file type to create when the event occurs.
AVI File
Creates a short .AVI format video file.
JPEG Files (Streaming 1 must be set MJPEG)
Creates a series of JPEG files at about 1 FPS.
JPEG File (Single JPEG at Interval)
Creates a single JPEG image file at time of event.
12.10.4- Record Time Setting
Pre Alarm
Amount of time prior to the event to start the recording, from 0-5 seconds.
Post Alarm
Amount of time after to the event to stop the recording, from 0-10 seconds.
Note: The Encoder cannot currently record for the entire time of a motion event.
Each recording generated by the Encoder will be no more than about 15
seconds long. For motion events lasting longer than the time set for Interval
above, multiple recordings will be saved. In such cases there may be a gap of
several seconds between recordings.
12.10.5- Network Disconnected
Disconnected
Select to save recordings to a SD Card installed in the Encoder when connection
to the network is lost. A SD Card (not included) must be installed for this feature to
function.
for detail on how to configure motion detection.
Saves record file to a configured FTP server
Saves record file to an installed SD Card
Activates a device connected to the relay outputs
© 2013 Wirepath™ Surveillance
Advertisement
Table of Contents
