WPS-300-ENC-4IP Installation Manual
7- System Diagram Considerations
7.1- Recommended Equipment
7.1.1- Networking Devices
Streaming content from IP Encoders requires bandwidth greater than most devices. We recommended the use of 1Gbps routers and
switches in order to maintain a high quality streaming image. Additionally, to reduce traffic on the overall network, we recommend
that all IP Surveillance devices be connected to a dedicated 1Gbps switch or dedicated VLAN.
7.2- Basic System Diagram
Wirepath
Analog
Bullet
1
3
2
4
VIDEO INPUTS
VIDEO OUTPUTS
7.1- Placing the Encoder
The WPS-300-ENC-4IP Encoders contain vents for cooling; these vents should not be blocked in order to maintain proper device
operation.
A minimum of 3" of free space is required on the sides and rear of the unit to maintain proper air flow.
Pg. 14
Wirepath
Analog
Dome
1
3
1
3
2
4
2
4
AUDIO INPUTS
AUDIO OUT
Wirepath IP Encoder
3"
Minimum of 3" of depth behind unit for cooling, and to
accommodate cables and connectors.
RS-232
12V DC 1.5A
INPUT
ETHERNET
AC
Power
Minimum of 3" free air space on each side.
1Gbps Switch
1Gbps Router
Internet
3"
3"
© 2013 Wirepath™ Surveillance