Table of Contents
Advertisement
8- Installation
1. Place the Encoder
See section
2. Install the SD Card (Optional)
The SD Card slot is located on the front of the encoder.
3. Connect The Encoder to the System
Recommended Cabling
Ethernet
DC Power
Audio In/Out
A.
Connect the Ethernet connection to a Cat5e/Cat6 cable. The opposite end of the Cat5e/Cat6 will be connected to the
network switch.
B.
Connect the analog camera.
Recommendation: The analog camera should be installed and configured prior to completing the installation of the
encoder.
C. Connect the DC Power In to a 12V DC 1.5A power supply.
D. Connect the Audio In to a microphone feed from the camera, and the Audio Out to the input of an amplifier or PC.
(Optional)
E.
Connect the RS485 D+ and D- to a PTZ analog camera. (Optional)
See section
F.
Connect an Alarm output or input to the connecting block located on the front of the encoder. If no alarm functions are
being used, this step can be omitted.
See section
G. Connect the relay In and Out to control or be controlled by encoder functions.
See section
www.snapav.com Support: 866.838.5052
7.1-Placing the Encoder
for important guidelines on placing the encoder.
Cat5e/Cat6
16/2 (if using a remote power source other than a PoE switch)
16/2
6.2.3-Control Connections
6.2.3-Control Connections
6.2.3-Control Connections
for pin-outs.
for pin-outs.
for pin-outs.
WPS-300-ENC-4IP Installation Manual
Pg. 15
Advertisement
Table of Contents
