Table of Contents
Advertisement
6.3- Factory Reset
The Encoder can be reset to Factory Defaults when communication is lost or if all settings need to be cleared.
Note: This will erase all setting on the Encoder, we recommend that a backup file of the settings be saved prior to
performing a reset.
1. Unplug power from the Encoder
2. Connect a jumper between Pins 2 & 3 on the RS232 port.
3. Apply power to the Encoder, and wait 30 seconds.
4. Once the Encoder appears in the IP Installers device list, remove the jumper from Pins 2& 3.
5. The Encoder is now reset with DHCP enabled, reconfigure the Encoder.
www.snapav.com Support: 866.838.5052
Jumper between
Pins 2 & 3
5 4 3 2 1
9 8 7 6
WPS-300-ENC-4IP Installation Manual
Pg. 11
Advertisement
Table of Contents
