User Password; Ide Hdd Auto Detection - DFI P5BTX/L User Manual

3
P5BTX/L System Board User' s Manual

3.1.10 User Password

If you want another user to have access only to your system but not
to setup, set a user' s password with the " System" option selected
in the BIOS Features Setup. If you want a user to enter a password
when trying to access setup, set a user' s password with the " Setup"
option selected in the BIOS Features Setup. Using user' s password
to enter Setup allows a user to access only the " User Password"
option that appears on the main screen. Access to all other options
is denied. To set, confirm, verify, disable or delete a user' s password,
follow the procedures described in the section " Supervisor Password" .
If you forget your password, refer to the procedure described in the
same section.

3.1.11 IDE HDD Auto Detection

Use this option to detect the parameters for the hard disk drives
installed in your system. These parameters will then be automatically
entered into the "Standard CMOS Setup". The IDE HDD Auto
Detection screen displays the following categories of information: Size,
Cylinders, Heads, Precomp, LandZone, Sectors and Mode.
HARD DISKS
Primary Master:
OPTIONS
2 (Y)
1
3
The settings on the screen are for reference only. Your version may not be
identical to this one.
For hard drives larger than 528MB, you would typically select the
LBA type. Certain operating systems require that you select Normal
or Large. Please check your operating system' s manual or Help desk
on which one to select.
54
ROM PCI/ISA BIOS
CMOS SETUP UTILITY
AWARD SOFTWARE, INC.
TYPE SIZE CYLS HEAD RECOMP LANDZ SECTOR MODE
Select Primary Master Option (N=Skip): N
SIZE CYLS HEAD RECOMP LANDZ
853 827 32 0
853 1654 16 65535
853 827 32 65536
Note: Some OS (like SCO-UNIX) must be "NORMAL" for installation
ESC: Skip
SECTOR MODE
1653 63 LBA
1653 63 Normal
1653 63 Large