USB port
USB port
2.2.5.7 IrDA Connector
The system board is equipped with an IrDA connector for wire-
less connectivity between your computer and peripheral devices.
Connect your IrDA cable to connector J10 on the system board.
Make sure " UART2 Mode Select" in the Integrated Peripherals
setup of the Award BIOS is Enabled.
You must have the proper drivers installed in your operating
system to use this connector. Refer to your operating system' s
manual or documentation.
Hardware Installation
USB cable connector
USB port cables (optional)
Pin
Function
1
IRTX
2
GND
3
IRRX
4
IRR3
5
VCC
31
2