Table of Contents
Advertisement
ZN-S100V/ZN-S1000VE HARDWARE MANUAL
1. Press Reset.
The red Data LED will blink several times. When Reset function is activated, the red
Data LED will turn on. User may stop pressing Reset at this point.
2. When "Reset" function has been completed,
the green Data LED will turn on and Status LED and Data LED will blink together.
ZN‐S100V
Refer to 'Figure 2' and 'Figure 3'
1.While the camera is in use, press and hold the Reset button.
(Both the Status and Network LEDs are on.)
2.Release the Reset button after 3 seconds.
2010/2-1 D1A.02
16
Advertisement
Table of Contents
