Krell Industries HTS 2 Instructions For Use Manual page 42

Select Trigger Mode
Use the 1" 4. keys (80) to move the blinking cursor to the
MODE
for the desired trigger,
and press enter (83). The SELECT A TRIGGER MODE screen ap 3ears:
KRELL HTS
-SELECT A TRIGGER MODE-
0 ALWAYS OFF
1 MAIN AND ZONE 2
2 MAIN ONLY
3 ZONE 2 ONLY
OK
Trigger Mode 0: This trigger is not activated when the configured device is selected.
Trigger Mode 1: The trigger activates when the configured device is selected for main
or zone 2 listening.
Trigger Mode 2: The trigger activates only when the configured device is selected for
main zone listening.
Trigger Mode 3: The trigger activates only when the device is selected for zone 2
listening.
Use the 1" $ keys (80) to select the desired trigger mode and press enter (83) to select.
You return to the CONFIGURE 12 V TRIGGER screen, which now reflects the change you
just entered.
Note
If you press the prev button (79) on the remote before you switch devices, the triggers
that are on remain on, even if they are specified as off on the newly selected device.
This is for simulcast operation.
Adjust Trigger Delay
On the CONFIGURE 12 V TRIGGER screen, use the --> key to move the blinking cursor to
DELAY and press enter (83). Use the 1" $ keys (80) to increase or decrease the number
of seconds (range is from 0 to 30).
When desired trigger mode and trigger delays are set for all triggers, select OK in the
CONFIGURE 12 V TRIGGER screen, and press enter (83) to return to the CONFIGURE DEVICES
screen.
>
38 Krell Home Theater Standard