Heatilator ECLIPSE-32 Installation Manual page 31

Rear Vent
NOTICE: Once appliance is set up for top or rear venting,
it CANNOT be changed at a later time.
Figure 6.7 Fold the tabs toward the center of the fi re plug
(90º) and remove the insulation gasket.
Figure 6.8 Cut the metal retaining band and fold the
sides out.
NOTICE: Once the seal cap has been removed it CANNOT
be reattached.
Figure 6.9 Fold the center parts of the retaining band
toward the center as shown. Remove the seal cap.
Heatilator • ECLIPSE-32, ECLIPSE-36 Installation Manual • 2297-984 Rev. B • 6/15
Figure 6.10 Discard the seal cap, remove and discard
the insulation basket. Note: Once the seal cap has been
removed it CANNOT be reattached.
Figure 6.11 Attach the fi rst vent section (it will snap into
place). Slide the insulation gasket onto the vent section,
up against the appliance and over the tabs. Use four self-
tapping screws to secure gasket to outer wrap.
31