Basic Notions - Unox XVC Instruction Manual

Basic notions

The appliances can be used in MANUAL or PROGRAMMED mode.
The MANUAL mode implies that the following parameters for each cooking cycle are set by the user:
- airflow speed.
The parameters set are not saved and must be entered during each successive use.
PROGRAMMED mode makes it possible to:
sessions;
- use pre-set cooking programmes.
Each cooking cycle comprises 10 steps:
- STEP 1
- STEPS 2 ...10: up to 9 cooking steps, each characterized by different cooking parameters. Cooking does not
necessarily require all nine STEPS: set only those required.
The appliance automatically passes from one cooking phase to the next.
Ex. COOKING CYCLE
PREHEATING
- When the oven is connected to the power supply, the control panel switches on automatically.
- Button functions
single repeated pressing -> increases/decreases the value one unit at a time;
held down -> increases/decreases the value rapidly.
- If no button is pressed within 15 minutes and there is no operating appliance connected to the control panel of
LIT. Simply press the START/STOP button to reactivate the electronic controls.
If the oven's sound signal is too low, UNOX recommends installing its Buzzer kit to increase
the volume; the kit can be installed at any moment by a specialised technician.
10 min
STEP 1
150°C
speed 1
60% steam
:
reset button
RJ45 port
51
ChefTop
™
60 min
STEP 2
200°C
speed 3
20% steam
A reset button and an RJ45 port for servicing are series
features equipped on the right hand side of the oven.
A user interface kit is available at request:
contact UNOX for additional information.
BakerTop
STEP
3, 4, 5, 6, 7, 8, 9
not used
LED REMAINS
English
™