Do you have a question about the BakerTop and is the answer not in the manual?
Questions and answers
Warren Wilson
April 9, 2025
i need the drainage holes for the unit
1 comments:
Mr. Anderson
April 10, 2025
The drainage holes for the Unox BakerTop unit are located at the rear of the oven. The waste outlet pipe must be connected there to an open tundish drain using a rigid or flexible heat-resistant pipe.
Page 3
INTRODUCTION Dear Customer, We thank you for having purchased an oven / complementary accessory from the ChefTop™/BakerTop™ line. ChefTop™/BakerTop™ ovens are the climax of Unox research and guarantee minimum occupation of space with superlative performance while offering outstanding cooking management at any condition of use and load.
Page 31
™ ™ ChefTop BakerTop Post-connection checks Check the items listed in the table after connecting the oven to the gas supply or after adjusting to a new type of gas. √ Check: Check result The air-tightness of the gas circuit using NON-CORROSIVE foam substances.
Page 68
Display Description Effect Troubleshooting WF - OVEN ALARM WF01 Warning: cavity 1 probe The oven continues to run using the cavity 2 probe, therefore temperature adjustments may be less accurate WF02 Warning: cavity 2 probe The oven continues to run using the cavity 1 probe, therefore temperature adjustments may be less accurate...
Page 69
Effect Troubleshooting WD - VIDEO BOARD PE1705 WARNING WPURE Number of residual litres supplied The WPURE message appears by UNOX.Pure filter at zero when the oven detects UNOX. Pure filter depletion Contact the Customer Assistance Service WD10 Error in EEPROM CRC for...
Page 70
Display Description Effect Troubleshooting AL - PROVER ALARM AL01 Cavity probe alarm The prover stops any operating Contact the Customer Assistance cycle and stops any successive AL02 Communications failure alarm Service display screen settings AL03 No 230 V power supply to the The prover stops any operat- proover board ing cycle and stops any suc-...
Page 78
EN 203-2-2: 2006 Guarantee Installation of the UNOX product must be performed by an Authorised UNOX Assistance Service. The installa- tion date and appliance model must be documented by the end purchaser, by means of written confirmation or an installation invoice issued by the dealer or the Authorised UNOX Customer Assistance Service, otherwise this guarantee will not be valid;...
Need help?
Do you have a question about the BakerTop and is the answer not in the manual?
Questions and answers
i need the drainage holes for the unit
The drainage holes for the Unox BakerTop unit are located at the rear of the oven. The waste outlet pipe must be connected there to an open tundish drain using a rigid or flexible heat-resistant pipe.
This answer is automatically generated