Toshiba RAV-SM560AT-E Service Manual page 41

Toshiban lämmitys- ja jäähdytyslaitteiden jälleenmyyjä pääkaupunkiseudulla on Jäähdytinpalvelu RefGroup Oy
No. Item
5 Air speed
selection
(Continued)
Value in the parentheses indicates one when thermostat of
the remote controller works.
Value without parentheses indicates one when thermostat
of the body works.
• If the air speed has been changed once, it is not
• When heating operation has started, the air speed
• If the temperature is just on the difference boundary, the
• Mode in the parentheses indicates one in automatic
• In Tc ≥ 60°C, the air speed increases by 1 step.
3) In heating operation, the mode changes to [UL] if
4) If Ta ≥ 25°C when heating operation has started and
5) In automatic cooling/heating operation, the revolution
Outline of specifications
<HEAT>
Ta ( C)
L(L)
–1.0
(-0.5)
L(H)
(0) Tsh
H(H)
(+0.5) +1.0
H
(HH)
(+1.0) +2.0
HH
(+1.5) +3.0
(HH)
(+2.0)
+4.0
changed for 1 minute. However when the air speed is
exchanged, the air speed changes.
selects a upward slope, that is, the high position.
air speed does not change.
heating operation.
<Operation of duct only>
Standard High ceiling
COOL HEAT COOL HEAT
UL UL
L
L+ L
L+
M
M UL UL
M+ M+ L L
H L+ L+
H
M+,M M+,M
H H
thermostat is turned off.
when defrost operation has been cleared, it operates
with HIGH (H) mode or (HH) for 1 minute from when Tc
has entered in E zone of cool air discharge preventive
control (Item 6).
frequency of [HH] is set larger than that in the standard
cooling/heating operation. However the revolution
frequency is restricted in the automatic heating opera-
tion as shown in the following figure.
www.ilmalämpöpumput.com
E
D
C
B
A
SM560 SM800
Tap
Revolutions per
minute (rpm)
FD 320 320
FD 320 330
FB 330 340
FA 350 360
F9 360 370
F8 370 380
F7 400 410
F6 410 440
F5 420 450
F4 440 480
F3 480 500
F2 530 540
F1 580 580
– 41 –
Remarks
Tc: Indoor heat exchanger
sensor temperature
[PRE-HEAT] display
F5 F4
Tc
( C)
47
42
F5