Specification - DeVilbiss FLG-G5 Operation Manual

E
E
Read and follow all instructions and Safety warnings before using this
The FLG5 Gravity Spraygun is fitted with a 1.4 or 1.8mm Nozzle for topcoat
applications. Alternative 2.0mm Nozzle and Needles are available for primer use. The
FLG5 Gravity Feed Spraygun is approved to ATEX regulations 94/9/EC, protection
level;
Important: These Sprayguns are suitable for use solvent based coating materials. The
design uses EPA compliant atomising (Devilbiss Trans-Tech®) technology to reduce
overspray and improve coating efficiency. Nozzles and Needles are manufactured in
Stainless Steel. These guns are not designed for use with highly corrosive and/or
abrasive materials and if used with such materials it must be expected that the need
for cleaning and/or replacement of parts will be increased. If there is any doubt
regarding the suitability of a specific material contact your local Distributor or ITW
Finishing direct.
Example:
Air supply connection –
Maximum static air inlet pressure –
Nominal gun inlet pressure with gun triggered – 2.4 bar (35 psi)
Maximum Service temperature –
Gun Weight –
Airflow –
Gun body
Nozzle
Needle
Cup
ITW Finishing Systems and Products reserve the right to modify equipment specification without prior notice.
© 2005 ITW Finishing Systems and Products
Operation Manual
FLG5 – Gravity Feed Spraygun
Important
Description
Suitable for use in Zones 1 and 2
Model Part Number

SPECIFICATION

Materials of Construction
- Aluminium
- Stainless steel
- Stainless Steel
- Acetal and Stainless Steel
equipment
II 2 G X
FLG-G5-14
Universal
P
1
40°C
640g
277 l/min (9.8 cfm)
2
Nozzle Size
1.4 or 1.8
1
/ BSP and NPS
4
= 12 bar (175 psi)