Sirius XM RAdio Onyx EZ User Manual page 15

Vehicle Installation
3. Attach the Vent Mount to the Power Connect
Vehicle Dock using the 4 provided screws .
4. Before you attach the Vent Mount to the
vent, skip ahead and finish the remainder of
the vehicle installation so that the cables are
attached to the dock .
Note! For greater clarity, the next illustration
does not show the dock attached to the Vent
Mount, however, the dock should be attached
before continuing .
5. Once the cables have been attached to the dock, push the Vent Mount onto
the vehicle vent as shown (1) until it hooks on the rear of the vent louver (2) .
6. Rest the foot against the bottom of the vent (2), and adjust the tilt of the Vent
PUSH
Mount by repositioning the foot to the other adjustment hole (3) .
TIP! To remove the Vent Mount, push the mount into the vent . Then lift up until
disengaged from the rear of the vent louver, and remove the Vent Mount .
1
Dash
Vent
FOOT
Louver
2
Dash
HOOKED
Vent
TILT
ADJUSTMENT
HOLES
3
Dash
Vent
15