Advertisement
Available languages
Available languages
Basically, all work on the machine is to be performed while the machine is not
in operation. The sequence for shutting the machine down described in the
Operating Instructions must be strictly observed. Pumps or pump units handling
hazardous liquids must be decontaminated.
Immediately upon completion of the work, all safety and protective equipment
must be restored and activated.
Before restarting the machine, all points contained in chapter "Initial Start-up"
must be observed.
2.7 Unauthorized Changes and Manufacturing of Spare Parts
Any conversion or changes of the machine may only be undertaken after con-
sulting the manufacturer. Original spare parts and accessories authorized by
the manufacturer guarantee operational safety. Using non-authorized parts may
void any liability on the part of the manufacturer in case of consequential
damage.
2.8 Unauthorized Operation
The operational safety of the machine delivered is only guaranteed if the machi-
ne is used in accordance with the directions contained in Section 1 – General –
of the Operating Instructions. Limits stated in the data sheets may not be ex-
ceeded under any circumstances. Pumps must only be operated within the cha-
racteristics stated.
Cited Standards and other Documentations
DIN 4844 Part 1
Supplement 13
DIN 4844 Part 1
Supplement 14
3.
Transportation and Intermediate Storage
3.1 Prolonged intermediate storage in an environment of high humidity and fluctua-
ting temperatures must be avoided. Moisture condensation may damage
windings and metal parts. Non-compliance will void any warranty.
The carrying lugs of the motor are only intended to carry the weight of the
motor. A unit consisting of motor and pump must only be lifted by taking it by
the motor and the pump side at the same time.
3.2
CAUTION
Use only suitable and technically certified lifting gear to lift the pump. Only use
load suspension devices with sufficient carrying power.
4.
Description
The plastic pumps of series BADU Resort have been designed to circulate pool
water in combination with a corresponding filter unit. The parts in contact with
the transported medium are mostly of glass fibre reinforced polypropylene PP
GF 30 and thus possess excellent corrosion resistance against the pool water
and the usual chemicals for treatment of the pool water. The pump housing
does not contain any inserts, therefore it can easily be recycled.
Safety marking; Safety symbols W 8
Safety marking; Safety symbols W 9
43
Advertisement
