Funkwerk bintec R230a Quick Install Manual page 22

quick_reference.book Page 20 Tuesday, April 4, 2006 9:26 AM
3
Configuration
Note
20 bintec User's Guide
Any existing configuration is ignored but not deleted; the default parameters of
ex works state will be used.
To reset your gateway proceed as follows:
1. Turn the power off your gateway.
2. Press the Reset button of the gateway.
3. Whilst pressing the Reset button, reconnect the gateway to the mains sup-
ply.
4. Watch the LEDs:
– First the Power and Status LEDs will light up.
– The Ethernet LEDs (1 to 4) for ports that are connected to the Ethernet
will flash.
– The boot sequence is started.
– Release the Reset button after the Status LED lit up five times.
If also the user passwords are to be reset to ex works state, please follow the
following instructions:
1. Select option (4) D
ELETE CONFIGURATION
instructions (for details about the BOOTmonitor handling see bintec User's
Guide chapter Gateway Management).
or
2. Carry out the reset procedure as decribed above and enter erase
bootconfig as L into the login prompt and press Return. The password
OGIN
is left empty. After pressing Return the gateway starts up with the boot se-
quence.
Now you can restart the gateway configuration as described starting from
"Configuration" on page 9.
of the BOOTmonitor and follow the
Quick Install Guide