１-５-２ Connection Of Other Devices - Dynamic CCTV MX16 Manual

VGA Monitor / LCD Monitor
3
Mouse
4
CONFIG SWITCH
5
Refer to a further description of CONFIG SWITCH below.
1. The input video type must be either NTSC or PAL; these two types must not be used together.
2. Select the input video format (NTSC/PAL) using the CONFIG switch on the rear side of the product.
3. Select the output monitor type (VGA/TV) using the CONFIG switch on the rear side of the product.
4. CONFIG SWITCH
1) VGA Mode
Resolution of VGA Monitor is SXGA (1280*1024) and CCTV Monitor output is supported.
2) TV Mode
CCTV Monitor output is supported but No VGA mode.
１-５-２ Connection of Other Devices
Connect the PTZ controller cable, audio input/output, network, and sensors as shown below.
Connecting Device
Mike / Speaker
1
LAN Cable
2
PTZ Camera
3
Sensor / Relay / TTL OUTPUT
4
Key controller
5
2) Audio Input/Output
Depending on models[16ch/8ch/4ch]], each of the models supports [16/8/4] line input and 1 line output.
3) Terminal Block
Terminal Blocks(TB1, TB2) in the rear of the product are for connections of PTZ / Sensor / Relay / TTL
Connection. Terminal Blocks may not be available depending on the model.
Rear Panel VGA-OUT
Front Panel USB
Rear Panel NTSC/PAL or VGA/TV Setup
Rear Panel Audio Input / Audio Output
Rear Panel Ethernet
Rear Panel Terminal Block
Rear Panel Terminal Block)
Rear Panel Terminal Block
[Figure 2-3. Terminal Block TB1]
[Figure 2-4. Terminal Block TB1 Description]
10
DVR Terminal
Operating Instruction & User's Guide