１-４２-８ Factory Default; １-４２-９ Rs232C Port; １-４２-１０ Alarm - Dynamic CCTV MX16 Manual

⑤ After selecting the file to be upgrade and a window shown below appears.
[Figure 6-46. Firmware Upgrade Progressing Window]
※ Downgrading to a previous version is not supported.
※ It is recommended that the DVR ID should be the same as the remote controller
ID.
※ The upgrade information window will then appear within 15 seconds.
⑥ Read the information and select {Yes} to start the upgrade gradually. Select Read the information and
select {Yes} to start the upgrade gradually. Select {No} to return to {System} mode to return to {System}
mode.
⑦ After the update is completed, the system will be rebooted.
⑧ The system will automatically start. Upgrade is then completed.
⑨ Move to {Menu} {Miscellaneous} {DVR Information}  {3. Software Version} to check the version.
※ All setup data are a fixed value in {Menu}{Setup}{System}{6.
Upgrade}{Setup}.
１-４２-８ Factory Default
① Move to {Menu}  {Setup}  {System}  {7. Factory Setup}.
② Select {Yes} when Initialization (Yes/No) Window appears.
Note that all setting data will be initialized.
※ It goes back to Factory Default Value.
１-４２-９ RS232C Port
① Move to {Menu}  {Setup}  {System}  {8. RS232C Port}.
② On the selection window, select the device using the arrow keys and the Select button.
１-４２-１０ Alarm
Alarm is to notify system incidents [Video Signal loss/ HDD full/ FAN fail/ HDD fail/ HDD warning] to [Alarm/ E-
Operating Instruction & User's Guide
74