１-５-１ Basic Connection; １-５-２ Connection Of Other Devices; [Figure 2-3. Terminal Block Description] - Dynamic CCTV MX-SDI Series Manual

１-５-１
Basic Connection
By referring to above [Figure 2-1] and [Figure 2-2], Connect the CCTV camera, HDMi monitor (or VGA monitor),
and USB mouse to the DVR and set up CONFIG SWITCH.
Connecting Device
1 CCTV camera
2 VGA Monitor / LCD Monitor
3 Mouse
4 CONFIG SWITCH
Refer to the CONFIG SWITCH description as below.
1. The input video type must be either NTSC or PAL; these two types must not be used together.
2. Select the input video format (NTSC/PAL) using the CONFIG switch on the rear side of the product.
3. Select the input video resolution between 1080p and 720p. These two types must not be used together.
１-５-２ Connection of Other Devices
Connect the PTZ controller cable, audio in/output, network and sensors as below.
1 Mike / Speaker
2 LAN Cable
3 PTZ Camera
4 Sensor / Relay / TTL OUTPUT
5 Key controller
1) Audio In/Output
Audio supports 4 inputs and 1 output.
2) Terminal Block
Terminal Block on the rear panel is for the connections of PTZ / Sensor / Relay.
Rear Panel Video Input
Rear Panel VGA-OUT
MX-SDI series: on front panel
Rear Panel NTSC/PAL or VGA/TV Setup
Connecting Device
[Figure 2-2. Terminal Block Description]
10
DVR Terminal
DVR Terminal
Rear Panel Audio Input / Audio Output
Rear Panel Ethernet
Rear Panel Terminal Block
Rear Panel Terminal Block)
Rear Panel Terminal Block
Operating Instruction & User's Guide