EVERY 1000 HOURS OR FIVE YEARS
•
Replace accessory drive belt.
BEFORE PERIODS OF STORAGE
•
Refer to Storage procedure. See Storage section.
Flushing The Cooling System
Flush the internal water passages of the outboard with fresh water after each use in salt, polluted, or muddy water.
This will help prevent a buildup of deposits from clogging the internal water passages.
NOTE: You can have the outboard tilted or in the vertical operating position during flushing.
1.
With the engine turned off, place the outboard in either the operating position (vertical) or in a tilted position.
2.
Disconnect the flush connector from fitting on the bottom cowl.
3.
Thread a water hose into the flush fitting.
4.
Turn on the water tap (1/2 maximum) and let the water flush through the cooling system for about 15 minutes.
5.
When flushing is complete, turn off water and disconnect the water hose. Reinstall the flushing connector to
the fitting on the bottom cowl. Tighten the connector securely.
Top Cowl Removal And Installation
REMOVAL
1.
Pull up the font and side cowl lock latches.
MAINTENANCE
1.
36
ob01019
ob01020