Replacing The Battery; Resetting The Mc67 - Motorola MC67 Integrator Manual

Carefully press and briefly hold the tip of stylus on the center of each target that appears on the screen.
2.
Repeat as the target moves around the screen, then tap the screen to continue.
3.

Replacing the Battery

To replace the battery:
CAUTION
If the MC67 is in a cradle, remove it before performing a Safe Battery Swap.
1.
If the MC67 is in suspend mode, press the red Power button to wake the device.
2.
Press the red Power button. The PowerKey Action screen appears.
3.
Tap Safe Battery Swap. The Data Capture LED lights red.
4.
When the LED turns off, remove the handstrap.
5.
Slide the battery latch to the right. The battery ejects slightly.
6.
Removing the Battery
Figure 1-6
Lift the battery from the MC67.
7.
Insert the replacement battery, bottom first, into the battery compartment in the back of the MC67.
8.
Press the battery down until the battery release latch snaps (2-clicks) into place.
9.
Replace the handstrap.
10.

Resetting the MC67

There are three reset functions; warm boot cold boot and clean boot. A warm boot restarts the MC67 by
closing all running programs. A cold boot also restarts the MC67, and also initializes some drivers. Data saved
in flash memory or a memory card is not lost.
The MC67 backup battery retains data for up to 15 minutes. Replace the battery within 15 minutes to
ensure that application states are maintained and that data is not lost.
Battery Latch
1
Getting Started
2
1 - 7