Power Connection - Motorola MC67 Integrator Manual

Select a mounting location for the cradle. It should be flat, and must provide adequate support for the
1.
cradle.
NOTE If using the GPS functionality of the MC67, ensure that the vehicle cradle is positioned so that the MC67
has a clear unobstructed view of the sky.
Prepare the mounting surface to accept four #8-32 studs, using the mounting template below. Drill four
2.
holes with a #6 drill bit.
1.2"
Vehicle Cradle Mounting Template
Figure 2-21
Position the cradle on the mounting surface.
3.
Fasten it using four #8 washers and four #8-32 self-locking nuts.
4.
Do not install a VCD5500 Vehicle Cradle on or near an air bag cover plate or within an aerobic zone.
CAUTION
Also, do not install it in a location that affects vehicle safety or driveability.

Power Connection

Please read all of the following instructions before beginning.
!
WARNING A properly trained technician must perform the power connection. Improper connection can
damage your vehicle, cradle or MC67. Refer to the vehicle's Owner's Manual for instructions for
removing power.
To connect the cradle to power:
When setting up connection for this cradle, only use the power input cable, part number 25-61987-01R
CAUTION
or 25-128974-01R.
Locate the vehicle power source.
1.
1.5"
Accessories 2 - 19