Table of Contents
Advertisement
Industrial PCs MCR5000
4
C
OMMISSIONING
All supply leads and all required data leads have to be connected before commissioning.
Warning:
The device must be switched off before connecting or disconnecting any cables in
order to prevent damage to the electronics!
Warning:
This device may only be switched on after the required ambient temperature is
reached in order to avoid condensate accumulation. Make sure to meet the
permissible voltage requirements for this device.
Warning:
After switching off and before switching on you must wait for at least 10 seconds.
Note:
The screen of a data cable must always be connected with the connector housing
(EMC).
Note:
Under the embedded operating system, interfaces must explicitly be enabled and
required drivers must be installed for being able to use them.
4.1 A
VAILABLE INTERFACES
© ads-tec GmbH • Heinrich-Hertz-Str. 1 • D-72622 Nürtingen
23
Advertisement
Table of Contents
