Table of Contents
Advertisement
Industrial PCs MCR5000
M
ONITOR INSTALLATION AT THE
Warning:
The installation procedure described below must be carried out by at least 3
persons, due to the weight of the equipment.
Fix the monitor to the MCR 5000 device by using the pre-installed installation bracket.
Note:
The figure shows the installation bracket from the point of view of the monitor.
Please take care that the monitor plate is properly pushed into the guides provided
on the MCR 5000 case when attaching the monitor.
Subsequently, the monitor must be pushed beyond the retainer lobes. Make sure that the
installation bracket is flush with the MCR 5000 unit after installation.
© ads-tec GmbH • Heinrich-Hertz-Str. 1 • D-72622 Nürtingen
MCR 5000
19
Advertisement
Table of Contents
