Table of Contents
Advertisement
Industrial PCs MCR5000
4 C
OMMISSIONING
All supply leads and all required data leads have to be connected before commissioning.
Warning:
The device must be switched off before connecting or disconnecting any cables in order
to prevent damage to the electronics!
Warning:
This device may only be switched on after the required ambient temperature is reached
in order to avoid condensate accumulation. Make sure to meet the permissible voltage
requirements for this device.
Warning:
After switching off and before switching on you must wait for at least 10 seconds.
Note:
The screen of a data cable must always be connected with the connector housing (EMC).
Note:
Under the embedded operating system, interfaces must explicitly be enabled and required
drivers must be installed for being able to use them.
4.1 A
VAILABLE INTERFACES
© ads-tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden-Echterdingen
23
Advertisement
Table of Contents
